No products in the cart
Tremec Transmision Company has released a great Blog on manual Trans Syncros. See the Post Below:
Manual Transmission Synchronizers 101
“You can thank synchronizers for the quick, smooth transitions that you love when shifting your own gears. These unsung heroes in a manual transmission are critical to shift quality and performance.
We want to give you a better understanding of how they work and some of the key technical advancements in the synchros we use in TREMEC transmissions.
There are several variations in the specific configuration and components used in synchronizers, but this basic function is the same.
TREMEC Synchronizer Basics
These are the components that make up a typical synchronizer assembly. This specific design is used in the TREMEC T-5 and TKO 5-speed transmissions.
In every synchronizer assembly, there are three primary components:
Slider, also referred to as a shift sleeve
Keys, balls or struts, depending on the specific design of the synchronizer
Blocking rings, also referred to as baulk rings
In most manual transmissions, gears ride on the output shaft and are meshed to gears on the countershaft. To engage a gear, the slider slides over the teeth on one of the gears. This locks the gear to the output shaft and completes power flow through the transmission from the engine to wheels.
The synchronizer adjusts shaft speeds and aligns the gears as you shift so the slider can mesh with the next gear.
There is more than one synchronizer assembly in a manual transmission. The exact number depends on the number of forward gears in the transmission.
Here a more detailed look at the synchronizer operation when you move the shifter to change gears:
Sliders push against the synchronizer keys, balls or struts, and those push against the blocker ring or baulk ring
The blocker ring is pushed against the cone on the gear, and friction causes shaft speeds to equalize
At equal shaft speeds, keys and notches in the blocker ring align
Slider teeth mesh with teeth along the outside diameter of the blocker ring
The teeth on the blocker ring act as an alignment ramp, allowing the slider to mesh with teeth on the gear
You can watch how the process works in this animated video.
You can see the blocker and friction rings from the TREMEC TR-6060 and Magnum at left and the T-56 at right. Note that the number of friction surfaces is what designates the basket as a double or triple cone.
A further improvement on the standard synchronizer design are multi-cone synchronizers, as used in the TREMEC Magnum 6-speed transmission. The multi-cone design increases the amount of friction surface area the synchronizer can utilize to sync the gear speeds, making for even quicker shifts and raising the rpm range.”